Jessen Tile Fix

Surface Preparation Clean substrate to be tiled and remove any foreign matter. Patch and level depressions and protrusions on substrate.Mixing Mix a 25 kg bag of tile fix powder with 6-7 litres or 3 parts or powder to 1 part of water with a hand-held electric mixer until smooth and creamy in texture. Allow mixture to stand for 10 minutes and stir the mixture again. The mixture is now ready for use.Application Apply the mixture onto levelled substrate with a notched trowel. The mixture can also be applied onto the back-face of the tile. For large tiles and tiles with high ridges, both methods are recommended for best results.Prepared substrates should be tiled within 10 minutes. Press tiles firmly onto tile base and knock into position immediately.If tiling is done under direct sunshine or windy conditions, work on smaller areas to avoid premature drying out which can cause poor adhesion. Back to TopTechnical Data Basic Binder Portland Cement, ASTM C150, Grey Filler Materials Clean, graded limestone powder and/or sand Additives Water soluble additives to improve workability, open-time, bond-strength, etc. Consumption 3-5 kg/m2 depending on substrate and back-face of tile. Packing 25kg bag Shelf Life 6 months under dry shade

  • Country:Malaysia
  • telephone:60-605 357 3679
Jessen Tile Fix is a high-quality, water-resistant, dry-set mortar for tile fixing.
*Your name:
*Your Email:
*To:LA Jessen Sdn Bhd
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters Remaining: 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

We do inquire for you , please wait ...

Jessen Tile

Surface Preparation Grout only after the tiles are set and dried (24 hours for wall tiles and 48 hours for floor tiles).MixingMix according to amount required. Use clean water and mix to a creamy consistency. Pot life is approximately 1 hour.ApplicationApply grout with a rubber ...

Come From LA Jessen Sdn Bhd