Mns Low Voltage Fixed Type Switchgear/ Indoor Intelligent Type of Low Voltage Switchgear

FOB Price
USD $7,000.00 / Piece
Place Of Origin
China (QINGDAO)
Shell Protection Grade
IP-33
Short Circuit Closing Current
31.5 Ka
Minimum Order
1
Rated Current
630A
Transport Package
Wooden Case
Packaging
N/A
Delivery
15 Days

MNS low-voltage drawer type switchgear (hereinafter referred to as switchgear) is developed by our company after referring to Swiss ABB's MNS series low-voltage switchgear and making comprehensive improvement.The products are composed of standardized, serial modules, and the drawer has a reliable mechanical interlock device, which makes the user safer and more reliable when using.
The switch cabinet is suitable for use in ac 50 Hz (60), rated voltage 400 v, 660 v, rated current under 5000 a and three-phase five wire of electric power supply system, can be used in power plants, substations, industrial and mining enterprises, hotel, airport, dock and radio and television communications center, for power generation, transmission and distribution, power conversion and power consumption equipment control, and through the ark to its main bus-bar capacitance compensation for reactive power compensation.


Conditions of use
1. For indoor use, the elevation of the service point shall not exceed 2000m.
2, the ambient air temperature is not higher than +40 degrees, not lower than negative 5 degrees.The average temperature should not be higher than +35 degrees within 24 hours.When exceeding, the capacity should be reduced according to the actual situation.
3. The relative high temperature of the surrounding air is +40 ° c and does not exceed 50%, and a large relative temperature is allowed at a lower temperature;If +20 degrees is 90%, consideration should be given to the effect of occasional condensation caused by temperature changes.
4. When the device is installed, the tilt with the vertical plane shall not exceed 5°, and the whole set of cabinets shall be relatively flat in line with the standard of gbj232-2.
5. The device shall be installed in a place where there is no severe vibration and impact and no corrosion of electrical components is sufficient to use



  • Country:
  • Business Type:
  • Market:
  • Founded Year:
  • Address:
  • Contact:Martin Tang
*Your name:
*Your Email:
*To:Qingdao Hengfengyou Electric Engineering Co., LTD.
*Subject:
*Message:
Enter between 20 to 3,000 characters. English only.     Characters : 0 / 3000
*Enter the secure code shown below Mfrbee security Image      Reload Image

submiting now We do inquire for you , please wait ...