Solar Controller RE40

LED DISPLAY

Load 1

0. to 7.for load two time setting

0 to 7 for load one time setting

Light+time modes :

This bypasses the 10 minute delay turn on.

Test mode:

The load is switched on and off as required. This is the Normal Mode.

The controller can also work without delayed switching .

Common Controller Mode:

There will be a 10 mins delay before turning on the load in order to make sure if it really gets dark.

The load will start working when it gets dark until it gets bright.

Light ON+ Light OFF control mode

Successful selection is set after 5 seconds when the digit stops flashing. Repeat process if required.

selected. 4  to 12 hour delays can be selected, in increments of 2 hours.

Ten minutes after darkness falls, the output switches on and remains on for the duration of the delay

An additional feature of this controller is a timed switched output.

The decimal point indicates that the output will be switched on and off at Load 2.

0  1  2  3  4  5  6  7  0.  1.  2.  3.  4.  5.  6. 7.

again. On the second time through zero,  the decimal point will stay lit. ie

Each press of the button, will now increment the displayed number  from 0 up to 7 and then back to 0

To enter this mode, press and hold the on/off button ( 5 seconds) until the number on the LED screen begins to flash.

Mode Setup:  (battery must be connected.)