PAM

4.       Jinyu can provide the best technological support and service and help customers choose.to achieve ideal treatment result, therefore to lower the cost.

3.       After the preparation of dilution solution following the above methods, reasonable amount of solution should be added according to practical test of water quality and treatment efficiency.

2.       Based on different application field, inorganic flocculants can be combined for use to achieve the best efficiency of product application.

1.       Based on different water quality, quantity and series of product can be determined by experimental test.

Usage of Products

7. Formation of two layers for the emulsion after long time of storage does not affect the quality of the product and the emulsion can still be used after stirring to form homogenous phase.

6. Low concentration of product solution should be prepared freshly for use and the storage time can not exceed 24h, otherwise, the quality of the product could degrade.

5. Normally, the product can be dissolved in water at room temperature, with no heating needed. In cold weather like winter, the solution temperature can be raised up to 30-40 to increase dissolution speed, but should not exceed 60 to avoid degradation of the product.

4. The speed of stirring or agitation should be in a proper range. Relatively slow speed can cause increase of dissolution time and low level of dispersion; in contrast, too furious speed can break the linear chain, consequently, damaging the relevant properties of the product.

3. Water used to prepare solution should be neutral. Normally, tap water is fine in this process, no specific requirement.

2. During the process of dissolving the product, stir slowly while adding the product slowly to half-water-filled tank, this can help the product disperse rapidly. Addition of product without stirring the mixture, or addition of water after product into the tank is forbidden to avoid the formation of big chunk, which is difficult to dissolve.

1, The concentration should be too high, normally between 0.05%-0.5%.

According to the properties of product, the followings should be noticed during the process of preparation and usage.

Feeding and Dosing

The Feeding-Dosing and Packaging-Storage of products

Nonionic PAM is mainly used as flocculants with high selectivity in oil well fluid,and acidic waste water treatment.

Cationic PAM is mainly used as flocculants and dewatering reagents for industry waste water and sewage; retention aids and intensifier in paper making industry; waste water treatment in pharmaceutical, leather making, printing and dyeing industry waste water treatment, and organizer in textile industry.

Anionic PAM is mainly used in minerals selection, , coal washing, food, steel, spinning and papermaking industry which involves separation of solid-liquid and waste water treatment. Anionic PAM can also be used for oil well and oil extraction in oil industry, and retention aids and intensifier in papermaking industry.

10~80

300~1200

C1060 series

10~80

300~1200

C1050 series

5~80

300~1200

C1040 series

5~60

600~1600

C1030 series

5~60

600~1600

C1020 series

5~60

600~1600

C1010 series

5~60

600~1600

C1005 series

Cationic Charge%

MW10⁴

Classifications

Cationic PAM

High flocculent ability and good thickening ability. The product can relatively easily dissolve in water to form viscous solution. Molecular weight of product can be adjusted according to customers request.

Product Characteristics

White powder or granula

Product Appearance

Solid PAM

PAM
High flocculent ability and good thickening ability. The product can relatively easily dissolve in water