electric Nail Drill Machine Beauty Machine Nail polish Beauties Machine

7.  If the supply cord is damaged, it must be replaced by the manufadturer , its service agent or similarly qersons in order avoid a hazard.

6.  Any unauthorized disassembling of the product is prohibited. In case of any breakdown, please contact the agent or authorized repair center.We promise swift, high-quality and satisfactosy service.

5.  For long idle time,please disconnect the source power.

4.  While the grinding head is in operation,never pull out the 5-pin plug of the portable grinding head.

3.  After operation,put the grinding head on the top of  the main panel.

2.  Turn the SPEED CONTROL counterclockwise to decelerate the gringding head to the minimum before turning off and switch the main power source to 0.

1.  Dont change the turning directions too frequently,otherwise it will damage the grinding head .

D.  Instructions

4.    Load speed 2700028000RPM

3.    No load speed 2900030000RPM

2.    Rated current 0.8A

1. Working voltage DC318V

b. Handpiece (motor)part

4.    Output current 0.8A

3.    Output rated voltage DC318V

2.    Ratad power input 15W

1. Rated voltage range 110120V,220240V  50/60Hz

a. Main(power supply & control) part

C. Specifications

5.Adjust the speed of the grinding head within a reasonable range.

4.The turning directions can be swappedFWD means clockwise direction and REV means counterclockwise direction.

3.When the function switch is pressed to FOOT,step on the pedal the speed will be accelerated,and loose the foot,the speed will decrease(foot switch is optional).

2.Turn the SPEED CONTROL to the right to accelerate the grinding head .And all the LED indicators for the speed will be on

1.Press the funetion switch on the right to HAND for manual control,the indicator will be on and the  grinding head starts to moving slowly.The diode LED 1-2 will be on.

B. Operation

5.Connect with the main source power.

4.Switch the speed control to the left.

3.Select grinding mould of different sizes according to actual requirements, and fasten it into the front of the portable grinding head.

2.Connect the pedal switch to the FOOT S/W socket.

1.Connect the 5-pin plug of the portable grinding head/hand piece to the OUTPUT socket at the main panel.

A. Installation and wire connection

Thanks for purchasing the Glazing machine produced by our company.To ensure smooth operation and safe performance,please read the manual carefully before use

Operation Manual

Thanks for purchasing the Glazing machine produced by our company. To ensure smooth operation and safe performance, please read

try drilling machine    nail drill    to get through more products