Versatile Hole Saw Notcher

One year parts and workmanship guarantee

14 day trial period guarantee

Satisfaction guaranteed

 Clamp mechanism rides in its own guide and has also been machined from a solid block of steel, eliminating the problems of tube walk in notchers that use a U-strap

Strong, accurate tube cradle machined from a solid steel block

Twin needle bearings and separate grease seals for maximum rigidity and reliability.

Ground and polished stainless steel shaft & rigid bearing block

Heavy duty frame with machined-in degree increments

Superb construction

Mounts vertically it in a drill press too

Use with a 1/2" hand drill so it can be used horizontally for greater flexibility -- just clamp it in a vise and go

Easy to use

Uses commonly available bi-metal hole saws costing approximately $8 each. (A single bi-metal hole saw will typically notch 5 to 10 complete racecars!)

Notches 3/4" through 2" O.D. tubing at angles up to 50 degrees in under 15 seconds.

• Large capacity and low operating cost