Led advertising module

     Step 1: Measure and mark the area where the module will be installed on the inside bottom of the letter housing. Refer to the Conditions of Installation (B) as provided above. 
    Step 2:  Take out modules from static-free bag (Handle with care. Avoid wresting, wringing, twisting of the module wire, it may damage the wire). Use 3M VHB Double-Sided Tape to bond modules to the marked position until the whole area is covered.
    Step 3: Secure modules on the inside bottom of the letter housing with self-tap screws. Avoid pressing the screw too hard, it may damage modules. 
    Step 4: Secure Power Supply at an appropriate location, connect the positive pole of the Power Supply to the orange wire of modules and the negative pole to the white wire. Wrap the junctions with thermoplastic tubes.
    Step 5: Connect all used Power Supply with the main power wire, and connect to fuse block (using a break), then connect to a power source through a switch.

Installation steps

3. No more than 3 strings of modules (total 60 modules) should be
 connected in each individual power supply circuit in series    connection.

2.Light module cannot use with strong corrosive chemical substances
together

1.Light module is low voltage product, must use switching power supply, absolutely forbidden access power system directly

attention:

Life span : more than 50,000 hours

LED type:  3chips,SMD5050
CE&RoHs standard

power: 0.72W
avialiable color:white,warm white, red, green ,blue
view angle: 140degree,

current:60mA,

voltage:DC12V,

Led advertising module

Led advertising module
DC12V, 60mA,0.72W
avialiable color:white,warm white, red, green ,blue
140degree, 3chips,SMD5050
CE&Ro