GAS LIQUID SEPARATORS TYPES 60-I AND 70-I INTERNAL

If you would like us to contact you regarding an application or product, please .

for Types 60-I & 70-I Internal Separators Literature.

Installation Considerations
To operate effectively, the internal separator must be located a minimum of 12 inches above the surface of the liquid, plus the pressure drop across the element in inches of water.

Sizing
See air and steam charts on pages 30 and 32. Use 65% of the equivalent air or steam flow when sizing internal separators.

These are centrifugal separators that cause the gas stream to enter a controlled centrifugal flow. This action forces the entrained liquids and solids to the outer wall of the internal separator where they fall to a bottom drain. The exit stream is drawn from the clean and dry center of the separator and that assures a clean and dry gas stream at the outlet. The Type 60-I has an upflow configuration while the 70-I has a downflow configuration. Both are fabricated from carbon steel and have 304L stainless steel blades.

Eaton Internal Gas/Liquid Separators are designed to be installed inside of receivers, steam drums and other vessels where they will remove 99% of particles and liquid droplets of 10 microns or larger from air, gas or steam.

Overview