Maintenance & Repair
*The problems of wearing parts, loose screw, environmental pollution, and bad lubricating probably cause the malfunction during the operation. You shall clear it promptly to make it run properly. Good attention to the maintenance will have a much longer use of steel strapping tools.
*Before every use, it shall be treated with lubricant.
*Timely remove the dust and dirt on the friction pulley.
It is pneumatic mode tools,with light weight,safe and convinent operation,strong banding power,well-locked,low labour intensity and easy to use.
It is hand operated, finish tensioning, sealing, cutting as a whole, greatly increases the packing efficiency. It is of latest design, compact and
durable.
* Combined, finish tensioning, sealing
* Efficient and safe, hands protective.
* Ergonomic design, easy to operate
* Strong joint, high bonding strength.
Contact information:
Contact:Leafit Ye
Phone:0086-18917584417
Portable Yt29 Hand Held Pneumatic Rock Drill Product Description YT29A Air leg rock drill is a heavy-duty air leg rock drill with the features of high speed and low consumption. It is suitable for railway, highway, hydropower and other construction. It is also a replacement ...
1. Part number: H820RP 2. Tyre diameter: 200mm 3. Tyre width: 44mm 4. Hub length: 39mm 5. Bore diameter: 12.7mm 6. Wheel bearings: No 7. Material: Rubber and plastic 8. Tire color: Black 9. Rim color: Any color 10. Load capacity: 40KGS 11. Packing: Cartons and pallets 12. ...
GEMQD-770J Series of portable hand-held flat pneumatic marking machine, computer editing, but also configure the microcontroller controller, small size, light weight, mobile printing; suitable for large equipment, heavy parts of the field hand-held printing, such as large pipe, ...
DA-ST512 Hand Held Device Approved SAE J2534 Pass-Thru. DA-ST512 Service Tool support english. DA-ST512 connects directly to the vehicle OBDII diagnostic connector. DA-ST512 Hand Held Device DA-ST512 Service Tool DA-ST512 Service Approved SAE J2534 Pass-Thru Hand Held Device ...
7655 Rock Drill chinacoal07 :hand-held type pneumatic rock drill; pneumatic rock drill; jack hammer;toyo rock drill;pneumatic drill Product Introduction 7655 rock drilling is a high efficiency rock drilling machine. It’s widely used in mining and roadway drivage of drilling ...
The pneumatic hand-held drilling rig suitable for the coal lane installation with the rock hardness acuities ≤f6, half coal lane of the coal bolting work. It could also drill the anchor hole, mix and install the anchors of the resin type. Technical Parameters Small in size, ...
ZQS-35/1.6S pneumatic hand-held drilling rig is suitable for rock bolting in roadway and half roadway where the hardness of rock is less than or equal to f6. It can not only drill rock bolt hole, but also stir and install resin cartridge type rock bolt. Main Characteristics 1. ...
QMZS1.7/11 pneumatic hand-held drilling rig suitable for the coal lane installation with the rock hardness acuities ≤f6, half coal lane of the coal bolting work. It could also drill the anchor hole, mix and install the anchors of the resin type. Main Characteristics Small, ...
Tension, seal and cut with one tool. Air power generates uniform tensioning and strapping efficiency. Recommended for coils, pipes, rods and irregular-shaped packages. Single notch sealer works with standard, super-duty and high- tensile steel strapping. Use with ...