ZIRMAX Zirconia Dental Restoration outsourced crown and bridge in china, reliable dental lab in china

ZIRMAX Zirconia Dental Restoration

ZIRMAX M is the high strength monolithic zirconia restoration that exceeds your expectations for multi-purpose zirconia restorations. Data shows that ZIRMAX M has a flexural strength of 1300 MPa, making it one of the strongest monolithic zirconia restorations available. Due to the strength of ZIRMAX M, it is indicated for a wide selection of restorative applications, including posterior, single units, wide span bridges, and even full arch restorations. Not just strong, but esthetic as well, ZIRMAX M has up to 25% more translucency than other high strength full zirconias.

ZIRMAX ME

ZIRMAX ME if you are looking for the strength and durability of a monolithic zirconia but need to push the esthetic envelope as far as possible, ZIRMAX ME is your best solution. It is more than 47% more translucent than any other zirconia and formulated to eliminate graying on lighter shades. Over 1000 MPa of flexural strength and suitable for up to 4 unit anterior bridges and 3 unit posterior bridges (extending to 1st molars), and esthetics that rival pressed ceramics with more than double the strength.

Full zirconia restoration fabricated by MYY Dental LabZIRMAX Key Features

Strong 1300 MPa (High strength 1300 MPa ZIRMAX can be used for cases that require maximum flexural strength)

25% more translucent than most high strength zirconia restorations.

ZIRMAX ME is more than 47% more translucent than any other zirconia.

10 Year Warranty

100 % Biocompatibility

Indications for Use

ZIRMAX M is ideal for posterior full crowns and bridges and can also be used as substructure for layered anterior single crowns and bridge restorations.

ZIRMAX ME is a good choice for anterior monolithic single crowns and bridges up to 4 units, bridges may extend to the second premolar.

Contraindications

ZIRMAX should be layered not monolithic in the anterior smile zone. ZIRMAX ME is a good solution for anterior monolithic restorations.

Clinical Handling

Preparation

It is not necessary to use a shoulder preparation, and feather edge preparations are acceptable. The ideal minimum margin preparation is .3 mm chamfer, but all margin preparations may be used, including a full shoulder.1 mm axial wall reduction

1 mm axial wall reduction1 mm cingulum / occlusal reduction required.

1 mm cingulum / occlusal reduction required

Note: As with any all-ceramic, no sharp or right angles.

Cementation Protocol

ZIRMAX can be placed with conventional cements, making it fit into whatever procedures work best for you in your clinical judgement.

ZIRMAX can be placed using adhesive systems with dual cure resins (RelyX Unicem, 3M ESPE; Panavia SA Plus, Kuraray. We recommend Z-PRIME from BISCO to prepare the inside of the crown for adhesive dentistry), or cemented using low expansion cements, like resin-modified glass ionomers, (RelyX Luting Cement, 3M ESPE; GCFuji Plus, GC America)

Adjusting & Polishing

When adjustments are necessary for fit, adjust prepped tooth. When occlusal adjustments are required on the monolithic zirconia material, use a diamond with water for ceramic adjustments of veneer porcelain.

When occlusal adjustments are required on the monolithic zirconia material, use a diamond with water for ceramic adjustments of veneer porcelain.

Avoid carbide use.

It is important to use ceramic polishing system to create a highly polished surface.