DESCRIPTION
MODEL:MSH095
NAME:Particle filtering half mask
USE:Protection against polluted gas and dust particles
MATERIAL:72.2% PP non-woven fabric + 27.8% melt-blown fabric
SIZE:12 X 11.5 cm
QUANTITY: 20 pcsper box
WARNING
〉This mask marked“NR” , shall not be used for more than one shift.
〉Never substitute, modify, add, or omit parts in the configuration as specified by the manufacture.
〉This mask helps protect against certain particulate contaminants but does not completely eliminate exposure to the risk of contracting disease or infection.
〉Do not use the particle half mask with facial hair or any other conditions that may prevent a good face-seal, the requirements of leakage will not be achieved.
〉Discard and replace the mask if:
1.The mask is removed whilst in the contaminated areas.
2.Clogging of the mask causes breathing difficulties.
3.The mask becomes damaged.
FITTING INSTRUCTION
〉1.Place under chin and press the mask freely against your face with the nose clip on the bridge
of your nose hands so.
〉2.Pull the headharness behind to ears ,attach the headharess to the retaining clip, improveomfort
and prevent leakage.
〉3.The headharness on the same side should cross above and below the ear respectively.
〉4.Using both hands, mold the metal nose clip to the shape of nose.To check for proper fit, cup both
hands over the mask and exhale vigorously. If air leaks around the nose,tighten the nose clip, if air
leaks around the edge, reposition the headharness for better fit.
〉5.Double check the seal and repeat the procedure until the mask is sealed properly.
( Entry into a contaminated area with an improper fitting mask may result in ilness or death.)