MGC1.1-6Stationary pontoon car

Introduction of mgc1.1-6 stationary box-type ore car products

Mgc1.1-6 stationary box-type ore truck is a main transportation equipment for coal and gangue transportation on the ground and underground roadway.At the same time, it is also a kind of short-distance transportation equipment for other non-metal ore, bridge, railway engineering, transport and driving driving engineering, etc.

Mgc1.1-6 is simple in structure and strong in durability. It has many advantages such as small resistance coefficient, large bearing capacity and convenient maintenance. When unloading, the car is turned over by a tipper.

The box and frame of the stationary harvester are fixedly connected, and the harvester must be turned over to unload.Its basic composition is car box, car frame, buffer, joint and travel mechanism.The frame is a metal structure, which can withstand the traction force, braking force, the impact force between the mining car and the rail impact buffer at both ends of the frame, to ease the impact force between the two cars.Coupler is the part that connects locomotive and harvester, commonly used have bolt link and rotary chain, big harvester USES the automatic coupler that has buffer action concurrently.The walking mechanism consists of four wheels and two shafts.When the sum of mining cars and materials exceeds 20 tons, the number of wheel sets shall generally be increased.For mining cars with more than two wheel pairs, two wheel pairs are formed into a small car with a rotary table to facilitate passing through the bend, which is called a bogie.

Mgc1.1-6 fixed tank car maintenance and maintenance

1. Regularly replace the wheel shaft bearing grease.The bearing shall be cleaned every 3 months and no. 3 calcium base grease shall be replaced.The amount added is 65 ~ 80% of the oil storage cavity.

2. The harvesters shall be repaired regularly every 3 months.

3. When the wheel and axle are assembled, it shall not be knocked randomly with a sledge hammer, but shall be pressed into the wheel and axle with no impact.

4. When mining cars are not in use, they are generally stored in open air.Regular inspection shall be carried out on the harvesters with long storage time.

Mgc1.1-6 technical parameters of stationary box-type mining cars

Model: MGC1.1-6

Volume: 1.10 m3

Nominal capacity: 1 ton

Maximum loading: 1.8 tons

Gauge: 600 mm

Dimensions: 2000mm long 880mm wide 1150mm high

The wheelbase: 550 mm

The wheel diameter: 300 mm

Traction height: 320mm

Rated traction: 60KN