1. The maximum lift of the rubber-lined impeller should not exceed 63m. The maximum allowable linear speed should not exceed 30m/m. 2. Bearings generally use rolling bearings and are lubricated with thin oil or grease. Their operating temperature should not exceed 75°C. 3. The ...
The AH slurry pump is a double-casing slurry pump. It has a high-chromium alloy lining and a rubber-lined lining. Today we will briefly talk about the characteristics of the rubber-lined slurry pump. 1. The head of the rubber-lined slurry pump does not exceed 63m; 2. Slurry ...
Rubber pump, AHR slurry pump, corrosion-resistant slurry pump generally means that the lining of the slurry pump is made of rubber. From the lining material of the slurry pump, it can be divided into rubber lining and metal lining (high chromium). The rubber pump is a slurry ...
AH type slurry pumps are commonly made of two materials: high chromium alloy and natural rubber. Today we are going to talk about slurry pumps made of natural rubber. Rubber slurry pumps are also called rubber-lined slurry pumps. They are characterized by corrosion resistance. ...
The common series of submersible slurry pumps produced by our factory include SP series and ZJL series. The SP series is further divided into SP and SPR. SP means that the flow parts are made of high chromium alloy, and SPR means that the parts below the flow parts and the ...
When analyzing the energy consumption under different adjustment methods, the article only analyzes the two widely used adjustment methods: valve adjustment and pump variable speed adjustment. Since the purpose of parallel and series operation of centrifugal pumps is to ...
Why is the pump shaft of the slurry pump relatively straight? Today we will talk about the straightness of the slurry pump shaft. (1) Straightening using a hand screw press This method can be used when the shaft diameter is small and the bending is large. First, place the shaft ...
Various problems will be encountered during the use of slurry pumps. Today we are talking about the reasons and solutions for the heating of the slurry pump body. 1. Incorrect selection of the slurry pump results in a mismatch between the pump and the motor, resulting in heat ...
When our fine sand recovery pumps are initially designed, we usually have one extra pump as a backup pump. So if the backup pump is never used, should it be left there forever? Of course not, our backup pump also needs to be cranked regularly. Let’s take a look at the role of ...
There is a correct gap value between the impeller and the rear guard plate of the slurry pump. We have previously introduced the method of adjusting the impeller clearance of the AH slurry pump. Today we will introduce how to adjust the impeller clearance of ZJ slurry pump. ...